Made in the USA and rated for 15-20 MPH
Will not warp, chip or crack
Easy one person installation
This Pallet of 36 Yellow Striped Rubber Speed Humps are made of tough, recycled tire rubber with a virgin rubber overlay that is resistant to weather, salt, moisture, ultraviolet light, oil and temperature.
This unit is great for parking lots, parking garages and alleys.
Molded-in stripes of yellow road marking tape let drivers know they are approaching a speed hump! Installation instructions included.
Dual bottom channels for drainage up to .75 inch diameter wires and pipes. Female/Male joints for each section. Use multiple sections to cover width needed. Removable for surface maintenance, snow plows or to relocate to a new site.
The flexible unit measures 2 feet long x 3 feet wide x 2.25 inches high with a recommended speed of 15 to 20 mph over hump. The design conforms to the contour of virtually any road surface. End caps can also be purchased to protect the speed hump ends and vehicles.
Picture above shows three speed humps and two end caps.
Please call for pricing on End Caps. Depending on number ordered, they may fit on top of Speed Hump Pallet. Part number SDSHEC is sold separately.
Six pieces of hardware sold separately for installation of one speed hump. Five extra hardware pieces are required for every end cap installation. For additional security you may also use the PL Premium, a polyurethane adhesive epoxy.
Use part number SDAS for asphalt hardware or SDSBCA for concrete hardware.